This paper is aimed to study the effect of SiC addition as reinforcement to 6061 T6 alloy. Al 6061 T6 alloy SiC composites were prepared by melting the alloy in a vortex and adding 4 % and 10% weight fractions of SiC. Then pouring the mixture into a mould to obtain a bar of 12 mm diameter and 150 mm length. Wear specimens were manufactured in dimensions of 20mm x 10mm according to ASTM to the base alloy and the cast matrix alloy. Microstructure have been carried out to understand the nature of structure and Hardness test also implemented to specimens. Adhesive wear test have been conduct both on the alloy and composites at different parameters (time, load and velocity). From the obtained results, it was found that wear resistance improved during the carbide addition comparing with the base alloy as a result of SiC addition which contributed in improving the hardness of the alloy that reflects to the wear resistance and these properties were improved as the increasing of the carbide silicon percentage.
The porous Titanium is characterized by high permeability which can assure the ingrowth of bone tissues, and consequently results in a good bonding between the metallic implant and the bone. In this work, Silicon element was added to the Commercially Pure Titanium at different weight percent of (2, 4, 6, 8 and 10) to investigate its effect on the porosity percentage, mechanical properties of the resulted samples. XRD analysis stated that at (Si) content lower than (2 wt%) the alloy is single phase (α- Ti alloy), as the Silicon content increased, in addition to (αphase), (Ti5Si3) intermetallic compound developed in the alloy. Porosity measurement results showed that the porosity percentage increases with the increase in Silicon content. Wear results stated that the wear rate increases with the increase in silicon content due to the increase in porosity percentage while the hardness results stated that there is no significant effect for Ti5Si3 intermetallic compound on improving the hardness of the samples. This is attributed to its low percent and the major effect of porosity on hardness which declined the effect of Ti5Si3 by reducing the hardness of the alloy compared with the master sample. The obtained results of the (yield strength, ultimate compressive strength and Young’s modulus) were within the values that match bone’s properties. This means these materials are suitable for biomedical application