In this paper, a proposed model based on phase matrix rotation was suggested to improve the performance of Multicarrier-Code Division Multiple Access (MC-CDMA) lies in Fast Fourier Transform (FFT) algorithm under the Additive White Gaussian Noise (AWGN) and frequency selective fading channel. This model is used to reduce the effect of multipath fading. The results extracted by a computer simulation for a single user, then it compared with the original technique for MC-CDMA based on FFT for both systems. As a result, it can be seen from the proposed technique that a high performance improvement was obtained over the conventional MC-CDMA, where the Bit Error Rate (BER) is widely reduced under different channel characteristics for frequency selective fading and the AWGN channel
The direct sequence (DS) spread spectrum communication technique is widely regarded as one of the most effective methods of mitigating the effects of a repeating jammer in military communications systems. The proposed system coupled DS with multiple frequency shift keying (DS/MFSK). It is comprised of a transmitter and a receiver. Non-coherent demodulation is examined, as are the spreading sequences in question. The effect of AWGN and Rayleigh fading channels on the proposed approach's bit error rate (BER) is examined. The investigation demonstrates that even with an 8 dB signal-to-noise ratio, superior outcomes can be achieved; this study's suggested endeavor is to create a novel transceiver system built on the DS/MFSK modular architecture. MFSK modulation prevents multiple-access interference, while DS is typically employed to boost system efficiency across erratic fading. Test results show that reliability on the AWGN channel decreases a little while reliability is greatly enhanced by Rayleigh fading. Moreover, notable improvements in bandwidth efficiency are achieved.
In this paper, a proposed structure was suggested by replacing the blocks of the fast Haar Wavelet Transform (WT) with a two dimensional wavelet transform at the transmitter and the receiver sides in the Orthogonal Frequency Division Multiplexing (OFDM) model. This can be done by converting a 1-Dimensional vector into a 2-Dimensional matrix and process it by 2-Dimensional Wavelet Transform (2D-WT). The proposed method was applied on the OFDM in Additive White Gaussian Noise (AWGN) and flat fading channel. It was concluded that the proposed method gives much better Bit Error Rate (BER) performance than the conventional OFDM model based on WT. The simulation results showed that the proposd structure outperforms the other scheme in the carried tests at the AWGN and flat fading channels.