The present research studies experimentally the effect of the ratio of the centurial hollow on the average of laminar convective heat transfer and the thermal gradation of the thermal boundary layer of three square flat plates. An experimental set-up was made for this purpose containing basically three uniformly Aluminum flat plates of a centurial hollow representing (0.25,0.5,0.75) of the entire surface area of each plate. Each of the three plates were heated by a constant heat flux for a rang of Rayleigh number of (5.62x105≤Ra≤1.67x106).The study showed that increasing the hollow ratio causes to increase the average of convective heat transfer by increasing the average Nusselt number, and the increasing average from a ratio to another decreases by the increases of the hollow ratio. The increasing between the two surfaces at (m=0.25&m=0.5) reached (39.6%) and for (m=0.5&m=0.75) was less than that and reached (29.2%).The increase average between the biggest and smallest hollow ratio was (78%).The study also showed that the maximum thermal gradation was on the out side edge of the plates and increases with the increase of Rayleigh number and the hollow ratio.
Viscoelasticity, as its name implies, is a generalization of elasticity and viscosity. Many industrial applications use viscoelastic matrix with reinforcement fiber to obtained better properties. Tensile testing of matrix and one types of fabric polyamide composites was performed at various loading rates ranging from (8.16* 10-5 to 11.66 * 10-5 m/sec) using a servohydraulic testing apparatus. The kind of reinforcement, random glass fiber (RGF), and the kind of matrix, epoxy (E) are used shown that the linear strain (،ـ 0.5) for the three parameter model gives a good agreement with experimental results. The results showed that both tensile strength and failure strain of these matrices and composites tend to decrease with increase of strain rate. The experimental results were comparison with numerical results by using ANSYS 5.4 program for simple study case has shown some agreement. Fracture regions of the tested specimens were also observed to study micro mechanisms of tensile failure.